50mm (2″) Cable & Chain System

Closed Tube Conveying

CableFeed specialises in the implementation of dry product systems for Agriculture, Food and Aquaculture, always focusing on the customers experience in regards to efficiency, reliability, technology and quality.

All CableFeed drive units are equipped with a friction drive pulling wheel. This unique principle transmits the power to the cable only by means of a friction grip on the cable discs. With our unique cable cleaning in-line brush and sweeping bends we can design a system suitable to your needs

Typical Layout

A Filling system is a basic feeding system, which provides feed from either one silo via a mechanical hopper or from two silos by using two motorized hoppers. The feed is pulled out from the silo and through drops filling f. ex., the feeders con- tinually one by one until the feed is reaches the completion detector. When completion detector detects the feed, the system stops. A typical filling system consists of the following parts:

TRANSPORT SYSTEM
• Drive unit + motor
• Hopper (manual or electrical)
• Corners
• Steel tubes
• Tube connectors
• Disc cable
• Cable connector
• Inspection section

FEED DROPS
• Feed drops
• Telescopic tubes
• Clamps Ø50-70 mm

CONTROLS
• Ready to Run control unit
• Relay kit for Controller (only electrical hopper)
• Silo switch (if two electrical hoppers are used)
• Contact clock
• Completion detector
• Eventually extra motor protectors

Calculation of the maximum length of the circuit

50mm_chart
Capacity:up to 1.0 Ton/hr
Motor:0.75 kw
Hoppers:1 hopper pulled by the chain equals 25 mtr
Length:220 meters (results depends on elevations, corners & drops)
Filling of System:75% of total tube length
Cable Speed: 23 mtr/ minute
Elevations:None. Every 1m of elevation reduces dimensioning length with 4m
Feed:
Pellets ø4mm x 15mm long
Service:Service and maintenance according to manuals.

DRIVE UNIT

HOPPERS

CABLE & CHAIN CONVEYOR

CORNERS

DROPS & DISPENSERS

PIPE

Spare Parts (38mm & 50mm Systems)